“The sliding tray makes my everyday products much easier to reach without taking over the vanity. Everything finally has a clear place.”
calavique™
calavique™ Bath Pillow
calavique™ Bath Pillow
Couldn't load pickup availability
Thoughtful Bath Comfort
calavique™ Bath Pillow
A softer place to slow down.
A soft over-the-rim bath pillow designed to support the head, neck and upper shoulders during an everyday soak. Its inner cushion rests inside the tub while the outer weighted flap settles against the exterior wall, creating a simple position-holding structure without multiple suction cups or complex installation.
Balanced Over-the-Rim Design
A flexible connection zone crosses the bath rim while the inner cushion drops into the tub and the outer weighted flap rests against the exterior wall. The structure is designed for simple placement and removal.
Support Where You Settle In
The broad curved inner cushion gives the head, neck and upper shoulder area a softer place to rest during a comfortable bath routine.
Easy to Lift Away
After use, remove the complete pillow from the tub, rinse it with clean water and hang it from the concealed loop so the surfaces can air dry.
Soft, Breathable & Considered
Comfort Without Complicated Setup
The pillow is shaped around a straightforward over-the-rim placement. There are no suction cups to repeatedly install, no rigid hardware and no permanent attachment to the bathtub.
Inner Cushion for Head and Neck
The approximately 36 by 25 centimeter inner pad provides a broad contact area that supports the head, neck and upper shoulder region without requiring a narrow fixed headrest position.
Outer Weighted Flap
A flexible weighted outer section hangs against the outside of the tub and helps the pillow remain positioned across the rim during ordinary relaxed use.
Three-Dimensional Quick-Dry Layer
The breathable three-dimensional knit surface and open buffer layer are intended to reduce trapped water inside the cushion. The pillow still requires rinsing and complete air drying after use.
Soft Anti-Slip Contact Points
Fine silicone contact dots on the lower surface add a softer point of contact against the tub area while helping reduce unnecessary movement on a clean, compatible rim.
Material, Scale & Placement
Rinse. Hang. Relax Again.
Warm ivory, soft sand and mist gray color directions bring a quiet lifestyle feel to the bathroom. The compact hanging loop makes post-bath care easy to build into the routine.
Fit Depends on the Bathtub Rim
The pillow is designed for common straight or gently curved bathtub rims within the suggested range. Check the rim shape, width and surrounding clearance before use. Do not treat the pillow as a safety support, grab bar or substitute for stable seating.
A Simple Bath Routine
Settle In. Support Your Rest.
The over-the-rim form keeps placement straightforward while the removable, rinseable construction makes the after-use routine clear.
Check the Tub Rim
Confirm that the bathtub edge is clean, stable and compatible with the pillow’s approximate 5–14 centimeter rim range.
Place Across the Rim
Lay the flexible connecting area over the bathtub edge. Allow the larger padded section to fall naturally toward the inside of the tub.
Settle the Outer Flap
Position the weighted outer flap against the exterior wall of the bathtub. Adjust the inner cushion so the head and neck rest comfortably.
Use While Relaxing
Lean back gently during a normal bath. Avoid pulling, hanging body weight from or using the pillow as a brace while entering or leaving the tub.
Rinse and Hang
Remove the pillow after use, rinse the surfaces with clean water, gently squeeze or shake off excess moisture and hang it from the concealed loop until fully dry.
Care Guidance
Rinse after every bath and allow the pillow to dry completely in a ventilated area. Do not machine wash, tumble dry, use high heat, apply chlorine bleach or leave the pillow submerged in standing water for extended periods.
Share
